Machines That Make Jewelry Chains Don't Need To Be Heavy. 

Jewelry is a small tool that enhances a person's beauty. We have a wide variety of necklaces, rings, cufflinks, earrings, and other beautiful jewelry. Limited to permanent ornaments that can be attached to the body. It is composed of beautiful stones such as pearls, gemstones, and coins. It is usually set in precious metals such as gold or silver. Here are some DIY tips: 

Basics: Thread the beads onto a wire spool and cut the wire, leaving 0.5 inch or 1 cm on each side. You can use needle-nose pliers to form these ends into loops. Do this with lots of beads, and you'll end up with a great necklace.

Create your own iPin. Cut the wire to the desired length. Trim the edges flat. Place one end of the wire behind the needle-nose pliers and wrap it around it. Next, use needle-nose pliers to bend the loop toward you. This is called a neck break and creates a bend at the bottom of the loop. Then, to form the eye needle, put the loop back into the round needle nosepliers and bend the wire until it is straight. Do this on both ends, if necessary.

Make the spiral: Cut the wire and size the spiral (remember the length you used if you are making more than one spiral of the same size). Next, twist the ends of the needle-nose pliers to curl the end of the wire into a neat circle. Next, grab the wire tightly with flat pliers and wrap it around, wrapping the smaller loop inside the other loop to connect it to your jewelry. Spirals are often created, either closed or open (slightly open to keep the area uniform). Open ones can also be designed unevenly, at least with short, jerky movements. Place a bead on it, make a small bead, and attach it to the larger bead. Hammer it flat.

S-Links: These areas are what I like to create. Therefore, it is simple but looks professional when completed. Cut the wire at a height of 9 cm and form two small loops in opposite directions at the ends of the wire. Then bend the wire at the bottom of the small loop and bend the large loop in the opposite direction. Repeat on the other side. Smooth the outside edge of the large loop with a hammer if necessary.

Of course, you can also use wire to create different shapes. Once you understand the basics, you can also use your imagination to create your own shapes. There are also several books on this subject.

Article Source: https://boostarticles.com

Join Us: https://boostarticles.com/signup